Max siope climbing angle: 50%
Max trench crossing distance: 165mm
Over climb obstacle height: 48mm
Super pivot turning
Track running sound
Main gun firing sound
Machine gun firing sound
Barrel wiggle sound
Barrel elevation sound
Shells back sound
Twin 380 motor
Hight-torque metal gearbox with self-lock one way transmission system
Metal running system
Precision machined aluminum gun barrel(buy separately)
Durable nylon tracks for long running life
Metal track for the real road feeling(buy separately)
VCU series controller uses 4 channels RC system to control R/C tank's forward/backward movement, sharp turning, pivoting, turret rotation and gun barrel evaluation at variable speed.
Plug-and-Play design for upgrading HL 1/16 RC Tank.
20A track motor driver.
22KHz, 8-bit high quality sound with digital sound mixer.
Maximum of 5 channel of sound track, main gun, machine gun, turret rotate, gun barrel elevation and engine sound can be generated at the same time.
3W sound output power.
Support air-soft gun with sound synchronization.
Support TAMIYA and HL IR battle unit and format.
Support RealEngine function.
Support RealRecoil servo port.
Safety shutoff prevents unwanted movement while signal lost.
Auto R/C signal detection.
Remote Control Syste
4-CH AM, FM or 2.4G
TAMIYA IR battle
Heng-Long IR battle
Engine Sound rendering
Frequency shift mode( Like el-mod)
RealEngine( Patent Pending)
Turret Rotation Speed Control
Gun Elevation Speed Control
Gun Elevation Servo Port
AirSoft with Sound Synchronization
( Patent Pending)
Head Light switch sound
Head Light on/off control
Switch + 30cm cable to connect to SW connector on MCU, not required for Heng-Long Tank
IR LED Cable
5mm IR LED + 30cm cable to connect to J1
Base and cable to connect MCU board to TAMIYA Battle Unit.
Control Mode and operation
VCU E66013/VCU E66023/VCU E66083/VCU E66143
Maximum current of track ESC
Maximum current of turret and cannon elevation ESC
Maximum supply voltage
Minimum supply voltage
Inspect metal portion on FETs and make sure they are not touched to each other after shipment.
Disconnect RX-18 and plug cables to the same connector on TKs,.
Set Sound Volume to middle
Connect a switch to Switch Cable Port, just to short 2 pins in SW port if you are using HL tank.
Connect a recoil servo to J2,
Set CH1, 2 and 3 trimmer on transmitter to center position, Set CH4 trimmer on transmitter to most left or right position,
Power on MCU board and transmitter, you should hear turret traverse sound. if not, please contact us.
gently move CH4(Multi function control signal 2) trimmer to center till turret traverse is gone.
gently move CH2(Throttle ) trimmer up and down if you hear motor hum sound.
Cannon firing sound should be generated and recoil servo should moves when move CH3 stick to most top position, if not, gently move CH3(Multi function control signal 2 ) trimmer up and down till it work correctly.
You are all set.
Carefully designed seven straight teeth reducer, full steel gear surface hardening treatment, low power transmission is more soft and delicate, high torque, high speed is explosive amazing, low-speed configuration deceleration ratio was 1:52, equipped with high speed reduction ratio 1:37.All ball bearing shaft configuration, single gear box contains 12 ball bearing,one pair gearbox up to 24 ball bearings,drive smooth and noise small, standard 380 brush motor, set aside holes upgrade can be destructive with the specifications brushless motor.Gear box end angle and minimum radius of only 7MM, is currently on the market the size of the smallest 1:16 special tank gearbox.Please specify the brand and model of the tank at the time of purchase to provide the appropriate output shaft.
Henglong Gearbox and Taigen Gearbox Size：